KA Tanking Slurry 25Kg White

Product Information

Note:all tanking products are prone to sweating during the drying out phase and if left exposed after the product has cured. We suggest they are always covered as above and / or adequate ventilation is installed to manage the humidity. The internal walls of a property are vulnerable to water ingress and damp. This means you are open to a whole load of potential problems. If you want to take steps to protect against this or deal with existing damp walls then you should consider wall tanking. We take you through the tanking methods available and the products you will need along with our usual no-nonsense advice.

Since the installation of tanking membranes involves making a watertight barrier using sheets of studded cavity drain membrane, a great deal of care and attention to detail must be taken. It can be applied either to the negative or the positive side and will negate dampness in ground water permeation even under hydrostatic pressure.In addition, PermaSEAL Tanking Slurry contains an acrylic polymer that improves strength, bonding and abrasion resistance. After hardening, PermaSEAL tanking becomes a vapour permeable and watertight coating capable of withstanding water pressure. Tanking Slurry Uses Apply second coat vertically once the first is dry but make sure this is done within 24 hours of the first coat drying Our tanking slurry is available in two colours, white and grey. As a general guide, use one colour for the first coat then the other for the second coat which makes it easier to see if you have completely covered the surface. Plastering over tanking slurry You may already know that tanking slurry is far from the only way to tank your basement or cellar – there are a couple of other options on the market – but it’s definitely one of the most effective. It’s also easier to apply than alternatives such as bitumen, which is a nice bonus. What is tanking slurry used for? Ready to get started? Here at Build & Plumb, we have all you need for tanking a wall. Shop a wide range of tanking slurry from leading and trusted manufacturers including KA and Bostik. Related articles

Tanking slurryis a great option because it can be applied with very limited damp proofing technical knowledge, has next to no structural impact and is a reliable way of keeping water out. Seal off any gaps - Using waterproof tape, make sure to cover up any areas where water ingress may squeeze through such as the joins between membrane sheets, around fixing plugs, or where the membranes reach the floor or cavity drainage system. Vandex BB75 Z is formulated to have enhanced sulphate resistance, making it suitable for use in sewage treatment plants and sewer / manhole refurbishment projects. Vandex BB75 / BB White / BB75 Z Application Preparation Properties in areas with a high water table, at flooding risk or on lower ground with little natural drainage could be at higher risk. They therefore require a more robust barrier to deal with any water ingress. Walls above ground level do not experience hydrostatic pressure that leaves tanking slurry as a good option. Next generation wall tanking products from Permagard

Using Tanking Slurry

Wall tanking or “tanking” is a method of preventing water ingress by creating a completely impermeable waterproof barrier on an internal wall. When we refer to tanking walls, it's usually in reference to below ground structures like basements or as a precautionary measure on damp walls above ground. The term “tanking” comes from the idea that by completely sealing a room, a waterproof tank-like barrier is created.